Oki Microline 320 User Manual

E – 9
Connecting to the Computer
These instructions are for the standard centronics
parallel interface.
1. Make sure that both the printer and the computer
are switched OFF.
2. Plug the interface cable into the port on the back
of your printer. Fasten the the cable using the
wire clips that can be found on both sides of the
connector port.
3. Plug the other end of the cable into the printer
port of your computer.
Wire clips
Parallel interface cable
Parallel interface connector

Oki Microline 320 Specifications

General

Print Method	Impact Dot Matrix
Emulation	Epson FX, IBM ProPrinter
Print Direction	Bidirectional
Resolution	240 x 216 dpi
Connectivity	Parallel
Paper Handling	Continuous Forms, Cut Sheet
Paper Width	Up to 10 inches
Noise Level	55 dBA
Number of Pins	9-Pin