Oki Microline 320 User Manual

E – 3
Important Safety Instructions
Your printer has been carefully designed to perform
safely and reliably. However, as with all electrical
equipment certain precautions should be allowed:
➢ Read all documentation supplied with and on
the printer before commencing.
➢ Always disconnect the printer from the mains
source before cleaning.
➢ Be certain that your power source matches the
rating listed on the back of the printer. If you
are using an extension cord, ensure that the
total rating does not exceed 15 amperes.
➢ Your printer has an earthed 3-pin plug, DO
NOT use this plug with a socket that is not
earthed.
➢ DO NOT make any adjustments, other than
those outlined in this manual, it could damage
the printer.
If you have persistent problems with your printer,
switch off, disconnect from the mains source and
contact your dealer for assistance.

Oki Microline 320 Specifications

General

Print Method	Impact Dot Matrix
Emulation	Epson FX, IBM ProPrinter
Print Direction	Bidirectional
Resolution	240 x 216 dpi
Connectivity	Parallel
Paper Handling	Continuous Forms, Cut Sheet
Paper Width	Up to 10 inches
Noise Level	55 dBA
Number of Pins	9-Pin