English
7Help Guide
Cleaning the Housing
You should clean the printer every six months (or after about
300 hours of operation).
Note: Never use solvents or strong detergents on the cabi-
net: they could damage the housing.
1. Turn the printer off, and remove any paper from the path.
2. Open the access cover, remove the pull-up roller
assembly.
3. Use a clean, dry cloth to dust around the carriage shaft
and platen. Remove any loose bits of paper.
4. Reinstall the pull-up roller assembly, and close the access
cover.
3320hlp3.pm6 13/03/96, 16:007
To Next Page
Loading...
