Getting started > 15
L
OADING
PAPER
For instructions on loading paper, see “Loading paper” on page 20.
Testing the printer
> Font Sample Test
> Rolling ASCII Test
> Hexadecimal Dump Mode
Font sample test
The Font Sample Test prints a sample of the fonts standard to the printer.
The top of the printout shows the Printer Model, Emulation, Country Code, Interface, and
Firmware Revision Level.
Make sure paper is loaded.
1. Turn the printer OFF.
2. Press and hold the LF key while turning the printer back ON.
The printer will print a page of font samples and the test ends.
CAUTION!
Wide carriage model: ML5521ECO/ML5591ECO:
If you are using 8.5 inch paper to run the tests, make sure the
paper width selection in the printer menu is set to 8.5 inches.
Otherwise, printing on the platen may damage the printer. See
“Menu mode” on page 41 for more information.
To Next Page
Loading...
Need help?
General
