Oki ML5520 - Print Quality and Character Pitch Configuration; Print Quality and Character Pitch (ML5590;ML5591)

Using your printer > 39
ML5590ECO/ML5591ECO
Press PRINT QUALITY (1) to select:
To select the typeface you want, press PRINT QUALITY (1) until the appropriate front panel
lights are on.
C HARACTER PITCH
Character pitch determines how many characters will print on each line. You can choose a
specific fixed width (10 to 20) for each character in characters per inch (CPI). The higher
cpi settings are often used for spreadsheets.
Proportional (PROP) sets character widths based on the character itself: e.g., the letter i is
assigned a narrower width than the letter m. This provides a more polished, typeset
appearance.
To select Proportional, press the CHARACTER PITCH key until both the cpi value and PROP
lights are illuminated.
To select non-proportional, press the CHARACTER PITCH key until the light for the cpi value
you wish to use is illuminated.
Near Letter Quality > Highest quality, lowest speed
> Courier or Gothic
Super Speed Draft > Lowest quality, highest speed
> Gothic typeface only
Letter Quality > Highest quality, slowest speed
> Choice of 7 typefaces
High Speed Draft > Lower quality, higher speed
> Gothic typeface only
Utility > Medium quality, medium speed
> Gothic typeface only
NOTE
Front panel settings for print quality and character pitch are normally
overridden by software commands.
1
1