Using your printer > 29
9. Press FF/LOAD.
T
OP
FEED
(
SINGLE
SHEETS
)
If you have continuous form paper in the path, press PARK to remove it before loading
single sheets.
Make sure the printer is on and deselected (SEL light off).
1. Move the paper lever (1) to the center position (marked “TOP”).
2. Open the acoustic cover (1) and raise the sheet guide (2) to the single sheet
position. Pivot the wire feed guide (3) up into the sheet guide.
NOTE
The factory default setting for the Top of Form (where the printing should
begin) is 1" down from the top of the page. To change the setting, see “Top
of Form (TOF)” in the previous chapter.
1
1
2
3
To Next Page
Loading...
