40496501TH Rev.1 152
P-1
• Is the connection of cables properly made to the CN1 and the CN3 on the PHA board?
Yes No
• Properly reconnect it.
▼
• Is the connection of cable properly made to the CN6 connector on the PMA board?
Yes No
• Properly reconnect it.
▼
• Is there any problem on the installation of Feed Jam sensor?
No Yes
• Properly reinstall it.
▼
• Can the printer recover after the FEED JAM and/or bail paper end sensor cable is replaced?
No Yes
• End
▼
• Can the printer recover after the PMA board is replaced?
No Yes
• End
▼
• Can the printer recover after the connection cable between the CN1 on the PHA board and the
CN6 on the PMA board?
No Yes
• End
▼
• Replace the PHA board.
To Next Page
Loading...
