To
Preset
Radio
Stations
The five pushbuttons labeled
1-5
can be used to set up
to
15
radio stations (five
AM,
five
FM1
and five
FM2).
1.
Tune in the station you want to store.
2.
Press TONE to select the tone setting that you prefer.
3.
Press and hold one
of
the five pushbuttons until the
display shows a channel number. The radio will mute
until the channel number is displayed. Whenever you
press that button again, the station and tone setting
will return. Always check whether you’re in AM,
FMl,orFM2.
1
A
SEEK
v:
When you press
SEEK
while playing the
radio, the radio will search for the next higher
or
lower
station and stop. The radio will be muted while seeking.
SCAN:
When you press SCAN while playing the radio,
the radio will go through each station, pausing for a
few
seconds at each station. Press SCAN again to stop on a
station. The radio will be muted while scanning and
SCAN will appear on the display.
When you press SCAN and hold it for about two
seconds until the display shows PSCAN (Preset Scan),
the radio will
scan
only stations that you’ve preset with
your radio pushbuttons. Press SCAN again to stop
on a station.
RCL:
When the ignition is
off,
press RCL (recall) to
display the time. When the radio is on, press RCL to
change the display between the radio station and the
time. After five seconds the display will return to its
normal display.
The radio can be set
so
that either the time or radio
station is normally displayed when the radio is playing.
To do this, press RCL to display the time or radio station
as desired, then hold
RCL
down until the display
flashes.
I
I
I
3-14
I
To Next Page
Loading...
