Olimpia splendid maeStro Pro - Top;Bottom Installation Configuration; Electronic Configuration For Lower Or Upper Wall Installations

MODE
Display
LED5LED1
B
ENGLISH
EN - 16
• This operation must be performed only by the installer or any similarly qual-
ied personnel and in compliance to the current national regulations.
• To prevent the risk of an electric shock it is mandatory to switch off the main
switch before performing the electrical connections or any maintenance op-
eration to the appliances.
To replace the power cord, proceed as follows:
a. Raisetheairsuctiongrille(3)andremovethetwoscrews(3a)(g.28).
b. Extracttheright(releaseusingascrewdriver)andleft(1a)doorsofthefrontcover,thenrotatetheap
(1)andremovethethreescrews(1b)andthetwoscrews(1c)(g.29).
c. Removethefrontcover(g.30).
d. Unscrewthetwoxingscrews(X2)toremovethefrontcoveroftheswitchgear(X1)(g.31) .
e. Unscrewthetwoxingscrews (X4) to remove the top cover of the switchgear (X3)(g.32).
f. Extract the switch towards the exterior of the switchgear (g.34-A).
g. Unscrewcableclippingclamp(J1)(g.33).
h. Unscrew the cables locking screws of the terminal board (J2)(g.33)
i. Extract the old cable and insert the new one by following the same path.
l. Lock the three poles of the cable in the terminal board (J2)andtightenthescrews(g.34).
m. Lockthecablewiththeclamp(J1)(g.34).
n. Close the switchgear .
o. Reassemble the front cover of the machine.
This operation must be performed by specialized personnel possessing the requirements indicated
by law.
2.5 - TOP/BOTTOM INSTALLATION CONFIGURATION
Theunitcanbeinstalledbothinthelowerpart(adjacenttotheoor)andintheupperpart(adjacenttothe
ceiling) of the wall.
Dependingoninstallation(ceilingoroor)itissufcienttochangetheelectroniccongurationsoastoopti-
mizetheapertureanglesoftheairoutletap.
2.5.1-Electroniccongurationforlowerorupperwallinstallations
 Workasfollows(seeg.B):
a. Insert the plug in the power socket to power the air conditioner, then
make sure it is switched to stand-by mode.
b. Press the key MODE for more than 10 seconds on the
control panel, until an acoustic signal is emitted.
c. The display shows parameter .
d. Release the key MODE and press it again.
e. Thedisplayshowsconguration (ceiling installation)
or (oorinstallation).
f. Press keys + or -toselectthedesiredconguration.
g. Press MODEtoconrm.
h. Press the key toexitfromtheconguration.