Olimpia splendid maeStro Pro - Operation in Ventilation Mode Only; Operation in Spa Mode Only (Automatic); Operation In Heating Mode Only (Only Models Fitted With Heating Pump)

ENGLISH
EN - 24
• Anyfantemperatureandspeedindicationthendisappearsfromthedisplay(LED6)ofthecontrolpanel
(g.C).
• Toactivatethismode,pressseveraltimeskeyB5 on the remote control until when symbol D3 and the
automatic ventilation symbol D18(fan+rstnotch)appearonitsdisplay.
• Inthisoperatingmodeitisnormalfortheairconditionertofunctionintermittently.
3.6.6 - Operation in “Ventilation” mode only
• Whenusedinthismodetheairconditionerdoesnotperformanyactionwithregardtotemperatureand
air humidity in the room.
• Toactivatethismode,pressseveraltimeskeyB5 on the remote control until when the automatic venti-
lation symbol D18(fan+rstnotch)appearsonitsdisplay.
3.6.7 - Operation in “Spa” mode only (Automatic)
• Inthismode,themachine’stemperatureisautomaticallyregulatedaccordingtotheroom’stemperature.
Thefanspeedisalsoautomaticallyregulatedaccordingtothesettemperature(exceptindehumidication
mode).
• Toactivatethismode,pressseveraltimeskeyB5 on the remote control until when symbol D5 appears
on the display.
3.6.8 - Operationin“Heating”modeonly(onlymodelsttedwithheatingpump)
• Usingthismode,theapplianceheatstheroom.
This function is only available for the versions with heat pump (HP).
• Toactivatethismode,pressseveraltimeskeyB5 on the remote control until when symbol D1 appears
on its display.
• Inthisrunmode,therequiredtemperatureandfanspeedcanbeset.Afterthreeminutes(maximumtime)
the compressor should start and the air conditioner starts heating the room.
The air conditioner has to defrost its battery periodically.
During this operation the air conditioner does not heat the room, though its internal
parts remain on except for the room air fan. when the outdoor temperature is very
low, there may be a slight delay for passage from the minimum to the medium or
maximum speed from when the command is sent to the machine with the remote
control.
Like delays might occur on activating the swinging function of the mobile bafe.
After having turned off the unit, the internal fan runs seconds more. Then it stops
and both air aps close.