Olimpia splendid maeStro Pro - Timer Activation and Deactivation; Reset of All the Remote Control Functions; Managing the Unit if the Remote Control Is Not Available; Recommendations for Energy Savings

MAESTRO PRO INVERTER
ENGLISH
EN - 27
3.6.15 - Timer activation and deactivation
Once set, the timer programs can either be activated or deactivated depending on occasional needs.
Activation may relate to one of the two programs or both.
In particular, each time you press key B9 (SET TIMER) (Programs activation), situation changes as follows:
• UseofProgramno.1only.
• UseofProgramno.2only.
• UseofPrograms1and2.
• Disuseofbothprograms.
3.6.16 - Reset of all the remote control functions
Replacing the batteries or removing them even for a few instants will cause all the settings of the remote
control to be reset.
In so doing, all the time settings of the timer saved in the remote control are cancelled and the remote control
restores all the factory settings.
3.6.17 - Managing the unit if the remote control is not available
In case of loss or malfunction of the remote control and/or exhaustion of the batteries, the appliance can be
controlled from the keys on board of the machine.
3.7 - RECOMMENDATIONS FOR ENERGY SAVINGS
Belowndsimplerecommendationsforreducingconsumption:
• Alwaysandconstantlykeeptheltersclean(seemaintenanceandcleaningchapter).
• Keep the doors and windows of the rooms to be climate controlled closed.
• Avoid the sun’s rays penetrating freely into the room (we recommend using curtains or lowering blinds or
closing the shutters).
• Donotobstructtheunitairow(inletandoutlet),i.e.inadditiontobadperformanceofthesystem,italso
affects correct operation and the possibility of irreparable faults to the units.
4 - MAINTENANCE AND CLEANING
Before proceeding with any maintenance and cleaning, always make sure the sys-
tem has been switched off, using the remote control, and the power supply plug
has been disconnected from the system socket (or the upstream master isolating
switch is positioned at “0” OFF).
Do not touch the metal parts of the unit when removing the air lters.
They are very sharp. Cuts or injury risk.