1-4-94
(20) Fusing is loose.
Print example
Defective part Check description Corrective Action
1
Paper 1. Check that the type of the
paper used falls within the
range of specifications.
2. Check the settings of the
type and weight of the paper.
1. If the type of the paper being used falls
outside the requirements, replace and use
a suitable type of paper.
2. If the settings made for the paper being
used is inadequate, configure the settings
according to the paper being used.
2
Paper weight set-
ting
Check If the weight of the paper
is correctly set.
If the weight of the paper is not correctly set,
choose the correct weight that matches the
paper being used.
3
Fuser unit Check the fuser pressure set-
ting.
Replace the fuser unit. (see page 1-5-44)
Service Manual
Y116540-5
To Next Page
Loading...
Need help?
General