Olympus bx40 - Page 17

BX40F
INTRODUCTION
This manual is written for the persons who can repair the BH2 series.
Repair
training
is
necessary
for
the
persons
who
have
no
experience
of
repairing
the
BH2
series.
*
The
disassembly
and
assembly
procedures
are
simplified
in
this
manual.
Disassemble the mechanical parts sequentially from © 5
Assemble in the reverse order.
adhesive and adjustment steps.
Pay attention to the grease,
Disassemble
the
electrical
parts
sequentially
from
@
with
attention
given
to
the
connectors.
Assemble in the reverse order.
adhesive and adjustment steps.
° For the adjustment, refer to the following pages.
[Example]
(Mechanical parts)
πι Disassembly
Pay attention to the connectors,
No.| Parts name Screw Grease Adhesive | Adjustment
© BOTTOM PLATE | CUK3x6SA(*1)4 pcs.
© | BLIND SEAL
@ | LEVER PUTB3x16SA(*2)1 pc. | OT1793 E8-3 (E-22)
SW3SA(*3) 1 pc.
KNW3SA (*4) 1 pc.
Assembly Reference item ———
Reference page
(Electrical parts)
No.| Parts name Connectors Screw Adjustment
© POWER BOARD (a) CNl --- Switch CSTS3x8SA(*1)2 pes.| El0-3 (E-32)
(b) CN2 --- Service outlet | CTK3x4SA(*2) 4 pcs.
(c) CN20 -- Display board
(d) Vout + Lamp (Gray)
(e) Vout - Lamp (White)