Olympus BX41 - Default Chapter; Table of Contents

BX41
CONTENTS
4
5-6
7-18
Correct assembly and adjustments are critical for the microscope to exhibit its full performance. If you are going to assemble
the microscope yourself, please read section 7, “ASSEMBLY” (pages 25 to 27) carefully.
IMPORTANT — Be sure to read this section for safe use of the equipment. —
1 NOMENCLATURE
2
3 USING THE CONTROLS
TRANSMITTED LIGHT BRIGHTFIELD OBSERVATION PROCEDURE
3-1 Base ..................................................................................................................................................................................................................... 7-8
3-2 Focusing Block .......................................................................................................................................................................................... 9
1 Voltage Indication; 2 Using the Light Intensity Preset Switch; 3 Using the Filters
3-3 Stage........................................................................................................................................................................................................... 10-12
3-4 Observation Tube ..................................................................................................................................................................... 13-15
3-5 Condenser ........................................................................................................................................................................................... 16-17
3-6 Immersion Objectives .................................................................................................................................................................. 18
1 Using Immersion Objectives
3-7 Objectives with Correction Collar .............................................................................................................................. 18
4 TROUBLESHOOTING GUIDE
5 SPECIFICATIONS
6 OPTICAL CHARACTERISTICS
7
19-21
22-23
24
25-27
PROPER SELECTION OF THE POWER SUPPLY CORD ......................................................................
28-29
1 Centering the Condenser; 2 Compatibility of Objectives and Condensers
1 Placing the Specimen; 2 Adjusting the X- and Y-Axis Knob Tension;
3 Rotating the Stage; 4 Adjusting the Stage Height
1 Adjusting the Interpupillar Distance; 2 Adjusting the Diopter;
3 Using the Eye Shades; 4 Using Eyepiece Micrometer Disks;
5 Selecting the Light Path; 6 Adjusting the Tilt
1
Replacing the Fine Adjustment Knob; 2 Adjusting the Coarse Adjustment Knob Tension;
3 Pre-focusing Lever
1-3
ASSEMBLY — See this section for the replacement of the light bulb. —
8 LAMP SOCKET INSPECTION SHEET
30