194
TROUBLESHOOTING
Operating Problems
SYMPTOM
The camera does not work.
POSSIBLE CAUSES
1 The power is OFF.
2 The batteries are loaded
incorrectly.
3 The batteries are
exhausted.
4 The batteries are
temporarily unable to
function.
5 Power has shut off to
conserve battery
consumption.
6 It is connected to a
personal computer.
CORRECTIVE ACTION
1 Set the Power switch to ON to
turn on the power.
2 Reload the batteries correctly.
3 Replace the batteries with
new ones.
4 Keep the batteries warm while
using the camera.
5 Operate the camera as
required.
6 The camera will not operate
while it is connected to a
personal computer.
REF. PAGE
P. 58
P. 33
P. 33
P. 19
P. 59
P. 187
SYMPTOM
No picture is taken when the Shutter button is pressed.
POSSIBLE CAUSES
1 The flash has not
finished charging.
2 The card access lamp
blinks after shooting in
the mode.
3 There is a problem with
the card.
CORRECTIVE ACTION
1 Remove your finger from the
Shutter button and wait until
the flash charge mark stops
blinking. Take your shot
again.
2 The recorded movie image
data is being written to the
card. You can start shooting
again when the card access
lamp stops blinking.
3 See the Error code chart.
REF. PAGE
P. 108
P. 203
To Next Page
Loading...
