79
PROTECTION
You can prevent accidental erasure of pictures you want to keep.
1
Set the mode dial to .
● The card access lamp will blink and
a list of stored images will be read
out. After that, the last recorded
picture will be displayed.
2
Display the picture you want to
protect. (DISPLAY AN IMAGE
(P.124), CLOSE-UP DISPLAY (P.126),
and INDEX-DISPLAY MODE (P.125).)
3
Press the OK button. The
displayed picture will then be
protected.
● will appear on the monitor.
To cancel protection:
Press the OK button a second time
while the picture is displayed.
will disappear and the protection will
be cancelled.
● The protected picture will not be deleted with All-Frame erase, but will be
deleted with Card format.
● Protection is not available when the write-protect adhesive seal is placed on
the card.
● The setting will remain until it is readjusted.
Note:
2
1
3
To Next Page
Loading...
