12 En
En
Memory gauge
The memory gauge lights up when you take a still picture. While the gauge is
lit, the camera is storing the picture on the card. The memory gauge
indication changes as shown below depending on the shooting status. The
indication is not displayed during movie recording.
Battery check
If the remaining battery power is low, the battery check indication on the
control panel and monitor changes as follows when the camera is turned on
or while the camera is in use.
Battery check Control panel Monitor Status
e Lights Lights (green)
(Goes off after a while)
Remaining power level: high
f Blinks Blinks (red) Remaining power level: low
If you intend to use the
camera for a long period of
time, charge the battery as
soon as possible.
No indication
The green lamp and orange lamp at the
side of the viewfinder blink. (The control
panel turns off automatically.)
Remaining power level:
exhausted
Charge the battery.
adcb
Before shooting
(Gauge is off)
No more pictures
can be taken
(Fully lit)
Wait until the gauge
returns to the status
on the left to take the
next shot.
One picture
taken
(Lit)
More than
two taken
(Lit)
Shoot Shoot Shoot
Wait
basic_e_x191_6.fm Page 12 Thursday, August 28, 2003 12:44 PM
To Next Page
Loading...
