16 En
En
J TURNING THE POWER ON/OFF
Power on
1 Remove the lens cap.
2 Pull the monitor out and rotate it.
• Some of the camera’s functions cannot be operated if the monitor is left
closed. Be sure to open the monitor before shooting or playing back
images.
• You can change the angle of the monitor.
3 Turn the mode dial until the mode
you want to use is aligned with the
red line.
4 Turn the power switch so that ON
is aligned with the ( mark.
• When the mode dial is set to a mode other
than q, the camera turns on in the
shooting mode. The monitor turns on and
the lens extends.
• When the mode dial is set to q, the
camera turns on in the playback mode
and the monitor turns on.
• You can also change the mode with the
camera turned on.
Mode
dial
Power
switch
basic_e_x191_6.fm Page 16 Thursday, August 28, 2003 12:44 PM
To Next Page
Loading...
