Olympus E-30 - Shading Comp; K Set; Pixel Count; Image Aspect

102
EN
Customizing your camera
7
SHADING COMP.
In some cases, the edges of the image may be shadowed due to the properties of the lens.
The shading compensation function compensates by increasing brightness at the dark edge
of the image. This function is especially useful when a wide-angle lens is used.
x Notes
• This function is not available when a teleconverter or an extension tube is attached to the
camera.
• At higher ISO settings, noise in image edges may be conspicuous.
K SET
You can combine 3 image sizes and 4 compression rates
and register 4 combinations. Select the registered setting
with [K].
g“Selecting the record mode” (P. 64)
PIXEL COUNT
You can set the pixel size for the image size [X] and [W].
[Xiddle] Select [3200 × 2400], [2560 × 1920], or [1600 × 1200].
[Wmall] Select [1280 × 960], [1024 × 768], or [640 × 480].
IMAGE ASPECT
You can change the aspect ratio (horizontal-to-vertical ratio) when taking pictures using live
view. Depending on your preference, you can set the aspect ratio to [4:3] (standard), [3:2],
[16:9], [6:6], [5:4] (for 8" × 10" prints), [7:6]/[6:5] (for 10" × 12" prints), [7:5], or [3:4]. JPEG
images are trimmed and saved according to the aspect ratio.
x Notes
• RAW images are not trimmed and are recorded with the aspect ratio information at the time of
shooting.
• During RAW image playback, images are displayed with a border based on the aspect ratio.
To use [IMAGE ASPECT] when taking pictures using the viewfinder:
j Set [ASPECT SHOOTING] to [ALL].
g“ASPECT SHOOTING” (P. 103)
To change the aspect ratio of recorded images:
j You can only change the aspect ratio when the aspect ratio of the image is set to [4:3].
g“Editing still images” (P. 87)
To trim recorded images:
j You can only trim images when the aspect ratio of the image is set to [4:3].
g“Editing still images” (P. 87)
 TIPS
D
SET
BACK
SET
PIXEL COUNT
Y
Y
arge
SF F N SF
XW
W
1 2 34
Register 4 different combinations
of image settings.
Set the compression rate.
Set the number
of pixels.
s0017_e_00_0_unified.book Page 102 Thursday, October 30, 2008 2:47 PM