51
EN
2
Exposure
The camera automatically takes pictures at a different ISO sensitivity with the shutter speed
and aperture value fixed. 3 images with different exposures are recorded in the order of the
set ISO sensitivity (optimum exposure when set to [AUTO]), exposure in the – direction, and
exposure in the + direction.
Compensation value: 0.3, 0.7 or 1.0
• The compensation value is set in 1/3 EV increments regardless of the ISO step setting.
Number of frames: 3
x Notes
• Bracketing is performed regardless of the upper limit set with [ISO-AUTO SET].
This overlays multiple frames and saves it as a single image. The image is saved with the
record mode set at the time the image is saved.
You can overlay an image while taking a picture or overlay a recorded image in playback
mode.
MULTIPLE EXPOSURE
In shooting mode, up to 4 frames of pictures taken can be overlaid and saved as a single
image. You can also select a stored RAW image and shoot multiple exposures to create an
overlay image.
[FRAME] : Select from [2F], [3F], or [4F] for the number of pictures to take.
[AUTO GAIN] : When set to [ON], the brightness of each frame is set to “1/the number of
picture taken” and the images are overlaid. When set to [OFF], the images
are overlaid with the original brightness of each frame.
[OVERLAY] : When set to [ON], a RAW image recorded on a card can be overlaid with
multiple exposures and stored as a separate image. The number of
pictures taken is one less than the frames set in [FRAME].
IMAGE OVERLAY
In playback mode, up to 4 frames of RAW images can be overlaid and saved as a single
image. g“Image overlay” (P. 89)
Setting display
• When multiple exposure is set, u is displayed on the
control panel and super control panel. When shooting is
interrupted, u blinks and i is displayed in green on the
super control panel.
ISO bracketing
Menu MENU[X][ISO BKT]
Multiple exposure
Menu MENU[X][MULTIPLE
EXPOSURE]
Control panel
FRAME
AUTO GAIN
OVERLAY
OFF
OFF
OFF
MULTIPLE EXPOSURE
BACK SET
s0017_e_00_0_unified.book Page 51 Thursday, October 30, 2008 2:47 PM
To Next Page
Loading...
