82
EN
Playback functions
6
6 Playback functions
The basic procedure for viewing pictures are as shown below.
However, before using any of these functions, follow Step 1 below. You can set the camera to
automatically switch to single-frame playback mode after shooting. g“REC VIEW” (P. 108)
1 Press the q button (Single-frame playback).
• The last recorded image appears.
• The LCD monitor turns off after more than 1 minute if no
operations are performed. The camera will turn off
automatically if there is no operation after 4 hours. Turn on
the camera again.
2 Use p to select images you want to view. You can
also turn the dial to switch to U for close-up
playback.
Single-frame/Close-up playback
q button
INFO button
p
< button
j
15
15
[4032x3024,1/8]
2009.03.16
21:56
100-0015
15
L
N
Press p to change the
close-up position.
Press p to move the display
of the close-up position.
When [g FACE DETECT]
(gP. 38) is set to [ON], a
frame is displayed around a
detected face. Press i to
move the frame to another
face.
Press bd to view frame-by-
frame close-ups.
When [g FACE DETECT]
is set to [ON], press ac
to move to another face in
close-up position.
• Press the INFO button to
return to close-up
playback.
(Single-frame) (Close-up playback)
Press the INFO button
a : Displays the frame that is
stored 10 frames back
c : Displays the frame that is
stored 10 frames ahead
d : Displays the next frame
b : Displays the previous frame
(Close-up position playback)
Press the INFO button
(Close-up frame-by-frame playback)
• To exit the playback mode, press the
q button again.
• Pressing the shutter button halfway
resumes the shooting mode.
Press the < button
• Plays back the image at a
10× magnified close-up
position.
U
G
s0017_e_00_0_unified.book Page 82 Thursday, October 30, 2008 2:47 PM
To Next Page
Loading...
