35
Installation
1. Ensure that both devices, the ESG-410 and the UHI-4 are switched off.
2. Firmly connect one plug of the communication cable to the LINK-IN socket or the LINK-
OUT socket of the UHI-4.
3. Fasten the screws on both sides of the plug to secure the connection.
4. Firmly connect the other plug of the communication cable to the LINK-IN socket or the
LINK-OUT socket of the ESG-410.
5. Fasten the screws on both sides of the plug to secure the connection.
6. Switch on both devices.
ESG-410
UHI-4
To Next Page
