34
Installation
4. Firmly connect one plug of the communication cable to the LINK-IN socket or the LINK-
OUT socket of the adapter.
5. Fasten the screws on both sides of the plug to secure the connection.
6. Firmly connect the other plug of the communication cable to the LINK-IN socket or the
LINK-OUT socket of the ESG-410.
7. Fasten the screws on both sides of the plug to secure the connection.
8. Switch on both devices.
4.7.2 Connecting the ESG‑410 to the UHI‑4
When connecting the ESG-410 to the UHI-4 also refer to the instructions for use of the
UHI-4.
Preconditions
‒ UHI-4 is available
‒ Communication cable “MAJ-1872” (10 m) is available
‒ ESG-410 and UHI-4 are switched off
To Next Page
