Olympus ESG-410 - Page 90

90
Maintenance
11.2.10 Reset to defaults
This function resets all settings to factory defaults. All settings are deleted when using this
function. User-dened procedures remain in the memory of the electrosurgical generator.
‒ Instrument settings: default
‒ Autostart delay: 1.0 s
‒ Non-split neutral electrode: Not allowed
‒ Monopolar modes: All modes
‒ Startup settings: All zero
‒ Maintenance Reminder: Disabled
‒ Language: English
‒ Touch tone: OFF
‒ Volume of activation tones: 7
‒ Brightness of the touchscreen: 5
‒ Date format: YYYY-MM-DD
11.2.11 PKCoag tones
For the mode PKCoag the 3 different activation tone sequences are available. This function
allows to select one of the following:
‒ Ascending tone sequence.
‒ Descending tone sequence
‒ Constant tone sequence. This is the default setting.
For more information refer to the section “17.2.2 Activation tones for bipolar modes” on page
102.
This function is password protected. To receive the password contact Olympus.