78
EN
Customizing the settings/functions of your camera
5
AEL/AFL memo
You can lock and maintain the exposure by pressing the AEL/AFL (AE lock) button.
MENU[Y][AEL/AFL MEMO]
[ON] : Press the AEL/AFL button to lock and maintain the exposure. Press again to
cancel the maintaining of the exposure.
[OFF] : The exposure will be locked only while the AEL/AFL button is pressed.
AEL metering
Sets the metering mode for when pressing the AEL/AFL (AE lock) button to lock the
exposure.
MENU[Y][AELMetering]
[AUTO]/[4]/[n]/[nHI]/[nSH]
• [AUTO] performs metering in the mode selected under [METERING] mode.
EV step
This allows you to change the EV step for exposure parameter setting, such as shutter
speed, aperture value, exposure compensation value, etc.
MENU[Y][EV STEP]
[1/3EV]/[1/2EV]/[1EV]
ISO limit
When [ISO] is set to [AUTO], you can set the maximum ISO that is set automatically.
MENU[Y][ISO LIMIT]
[100]/[200]/[400]
Compensating all WB
This lets you apply the same compensation value to all the white balance modes at once.
MENU[Y][ALL>]
[ALL SET] : The same compensation value applies to all WB modes.
[ALL RESET] : The WB compensation value settings applied to each WB mode are all
cleared at once.
If you select [ALL SET]
1) Use bd to select the color direction.
R-B RedkBlue/G-M GreenkMagenta
2) Use ac to set compensate value. g “WB compensation” (P. 59)
• You can check the white balance you have adjusted.
If you select [ALL RESET]
1) Use ac to select [YES].
Speed synchronization
You can set the shutter speed that will be used when the built-in flash fires. The speed can be
set from 1/60 to 1/180.
MENU[Y][#X-SYNC]
[1/60] - [1/180]
• For details on the synchronization speed of commercially available flashes, refer to their
manuals.
Other function settings
s0010_e_00_unified.book Page 78 Monday, April 9, 2007 6:12 PM
To Next Page
Loading...
