@ Attaching the Lamp Housing (lMT2-LSH)
Loosen clamping knob 0 of the lamp housing and connect the lamp
housing to the collector lens sleeve 0, and clamp. (Fig. 10)
*
The
precise focusing position of the lamp housing varies depending
upon the condensers. (See pages 14, 15, 16)
0 Mounting the Halogen Bulb
1) Press the spring levers @ of the bulb socket @ in the direction
of the arrow, and insert the bulb pins @I into the socket holes 0.
(Fig. 11)
* Use gloves or gauze to hold the bulb.
2) Release the levers and the bulb is held in position.
* Do not touch the bulb portion with bare hands. If fingerprints
or dust are left on the bulb, wipe them off; otherwise the bulb
life will be considerably reduced.
* Use a standard bulb as designated by Olympus (12V50WHAL).
If a 12V IOOW halogen bulb or other high power bulb is used,
the power circuit may be damaged.
Bulb to use:
Fig.
11
Standard
12V50WHAL: High intensity type; effective life
at rated conditions about 50 hrs.
Compatible
12V50WHAL-L: Long life type; effective life at
rated conditions about 2,000 hrs.
Fig. 12
0 Connecting the Bulb Socket and Cord Assembly
Insert the socket into the lamp housing and clamp with knob 0.
(Fig. 12)
Connect the cord plug @ to the receptacle at the back of the micro-
scope stand.
0 Mounting the Filters
1) Press the lever @ all the way down and insert a filter @ into the
filter holder 0.
* Hold the filter at its circumference to avoid leaving fingerprints
or
other
smudges on the filter surface. (Fig. 13)
2) Mount the frosted filter into the innermost filter holder, with the
frosted surface facing the operator. Mount the green filter into
the adjacent holder. The other 2 filter holders are provided to accom-
modate additional filters, optionally available, e.g. 43ND6-W45,
45.LBD-2N.
Fig. 13
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
