25
IPLEX NX
Attaching the long LCD cable
Loosen the clamping screws of the LCD connector covers of the main unit and the
LCD unit, and open the cover.
Remove the LCD cable from the main unit and the LCD unit.
Connect the long LCD cable to the main unit and the LCD unit.
Attach the waterproof rubber of the long LCD cable as shown above.
Close the LCD connector covers of the main unit and the LCD unit, and tighten the
clamping screws.
· Attach the waterproof rubber correctly and be sure to tighten the clamping
screws of the covers. Otherwise, the water resistant proof may not be ensured.
· Be sure to turn OFF the power before removing or attaching the LCD cable or
the long LCD cable.
Otherwise, the instrument may be damaged.
2
3
4
5
Clamping screw Clamping screw
1 3 4
Cover Cover
Waterproof rubber
To Next Page
Loading...
