88
Specifying and moving the measurement points
Re-specifying the measurement points or reference points
Re-measurement
Tap the position you want to move the cursor in the left image area. Tapping the up/down/left/
right button (
) moves the cursor position gradually.
Long-tapping the move button moves the cursor position continuously.
The object distance measured at the cursor position (distance between the distal end of
the stereo optical adapter and the measurement area) and measurement results are always
displayed.
Note that the object distance showing <-. - - - mm>, indicates that the correct reference point
was not automatically acquired.
If the incorrect measurement points or reference points were specified by mistake, select
<CLEAR>, in the measurement menu.
If you want to restart measuring on the image from the beginning, select <ALL CLEAR> in the
measurement menu and clear all measurement points and reference points.
4
Specification of measurement points
Displaying the zoom
If you tap the up button of the [ZOOM] button during the stereo measurement, the image
around the current cursor position and the image aground the corresponding point will be
displayed on the cursor zoom window and the corresponding point zoom window respectively.
If you tap on the left image area while displaying the cursor zoom window or tap the up/down/
left/right button (
), the zoom image will be moved and you can specify the cursor
position.
To change the zoom magnification, tap the [ZOOM] button
), the zoom image will be moved and you can specify the cursor
. You can set the zoom
magnification to 2X, 3X or 4X. Tapping the up button will increase the zoom magnification and
tapping the down button to decrease the zoom magnification.
If you tap the down button when the zoom magnification is set to 2X, the cursor zoom window
and the corresponding point zoom window will disappear.
To Next Page
Loading...
