Olympus IPLEX NX IV9435N - Page 98

90
5
<3D OPTION>
 Operating on 3D view area
The object for measurement can be displayed in 3D.
Select [3D option] on the measurement menu screen, and select the view mode from <2D/2D>,
<2D/3D>, <3D>, <2D/3D (color map)> or <3D (color map)>.
If the view mode is <3D> or <3D (color map)>, you cannot specify the measurement
points or reference points. The object distance mark(
) (see “ Spot ranging
screen” (page81)) indicating the object distance to the measurement point is
displayed on the right side of the measurement value.
TIP
Some functions are switched between the LCD unit and the remote control unit. For details, see
the table below.
Touch panel of LCD unit Remote control unit Function
long-tap
[MENU] button
long-press
Shows/hides the coordinate axis (X-axis
(Red), Y-axis (Green), Z-axis (Blue)).
long-tap
[LIVE] button
long-press
The 3D image view returns to the
original status.
tap
[SPOT RANGING] button
short-press
Changes the 3D image view direction in
the order of X-axis, Y-axis and Z-axis.
long-tap
[SPOT RANGING] button
long-press
The function of the [ZOOM] button
changes from the operation to zoom in/
out the image to the operation of the
cross section view.
*
[ZOOM] lever
Zooms in/out.
enlarges the image and reduces
the image.
In the operation of cross section view,
In the operation of cross section view,
moves the cross section from front
to back and moves it from back to
front.
* In the operation of cross section view, the cross section view icon (
* In the operation of cross section view, the cross section view icon (
) appears in the upper
right area the LCD monitor.