Olympus IR-500 - Erasing the Image Data Automatically after Storing Them Onto the Storage Unit (ERASE STORED IMAGE)

157
Chapter 7: Customizing your camera
Erasing the image data automatically after storing them onto the storage
unit (ERASE STORED IMAGE)
Using the custom button
1 Turn the mode dial to j,
k, i, n, o, l, or n.
2 Press c (z) to display the “CUSTOM BUTTON” screen.
3 Press a/c to select the desired function, then press 9.
Erasing the image data automatically after
storing them onto the storage unit (ERASE
STORED IMAGE)
You can let the camera automatically erase the image from the card after you store the image onto
your Dock&Done-compatible storage unit.
1 Turn the mode dial to q.
The setup menu appears.
Tip
Some functions registered to the custom button do not operate while the mode dial is set to n,
l, or n. To use the custom button, make sure that the registered function works while in the
mode set by the mode dial.
O
P
E
N
Q
U
I
C
K
V
IE
W
O
P
E
N
P
O
W
E
R
O
K
Mode dial
9 button
abcd button
O
P
E
N
Q
U
I
C
K
V
I
E
W
O
P
E
N
P
O
W
E
R
O
K
Mode dial
9 button
abcd button
s
00E Adam .book Page 157 Tuesday, November 9, 2004 3:24 PM