Olympus IR-500 - To Remove the Battery

32
Chapter 2: Preparation
About the battery and card
3 Close the battery/card cover.
To remove the battery
Press the battery lock lever in the direction of the arrow. The battery springs up so you can pull
the battery out.
Notes
• The camera does not work if the battery/card cover is not closed properly.
• Do not open the battery/card cover, disconnect the AC adapter, or remove the camera from the cradle
while the camera is operating or communicating with a computer. Such actions could destroy all the data
on the card. Once destroyed, data cannot be restored.
Note
If you leave the camera with the battery removed for about one day, the camera may restore the initial settings
even if “ALL RESET” (the setting for saving your custom settings) is set to “OFF.”
PUSH
O
K
O
P
E
N
PUSH
OK
O
P
E
N
PUSH
Battery lock lever
00E Adam .book Page 32 Tuesday, November 9, 2004 3:24 PM