33
Chapter 2: Preparation
Charging the battery
To remove the card
Push the card in. The card springs up so you can pull the card out.
Charging the battery
The supplied lithium ion battery (LI-12B) is not fully charged when the camera is purchased. Set
the camera on the supplied cradle to charge the battery before using the camera.
Note
If you release your finger quickly after pushing the card in or flick the card to remove it, the card may jump
out. Remove the card with care.
Tip
Make sure to turn off the camera by closing the multi-swing display or pressing the power switch before
charging. Charging cannot be performed when the camera’s power is on.
PUSH
OK
O
P
E
N
P
U
S
H
OK
O
P
E
N
00E Adam .book Page 33 Tuesday, November 9, 2004 3:24 PM
To Next Page
Loading...
