Olympus IR-500 - Using the Self-Timer y

55
Using the self-timer Y
Chapter 4: Setting according to shooting conditions
3 Press a/c to select the macro setting, then press 9.
Shooting mode resumes with the chosen macro mode setting. When macro mode is set,
& appears in the monitor. When super macro mode is set, % appears.
Using the self-timer Y
In the self-timer mode, the picture is taken approximately 12 seconds after the shutter button is
pressed.
1 Turn the mode dial to j,
k, i, n, o, l, or n.
2 Press a (Y) to display the self-timer setting screen.
Notes
• If you use the flash in & (macro) mode, shadows may be noticeable or the appropriate exposure may not
be obtained.
• The zoom or flash cannot be used in % (super macro) mode.
GO SELECT
OFF
O
P
E
N
Q
U
I
C
K
V
IE
W
O
P
E
N
P
O
W
E
R
O
K
Mode dial
abcd
buttons
9 button
Shutter button
00E Adam .book Page 55 Tuesday, November 9, 2004 3:24 PM