1
IMPORTANT
The IX2-UCB (Type 2) control box is the basic module for controlling the drive functions of the IX2
microscope with motorized specification. It also incorporates the power supply for the microscope. It
can be combined with one of the Type 2 microscope frames: IX81S1F-2, IX81S8F-2 and IX81F-2.
Motorized operation from the U-HSTR2 hand switch or a PC is possible. Besides, the functions of the
buttons can be set as desired by using the IX2-BSW software (Ver. 01.03 or later).
The IX2-BSW software (Ver. 01.03) is compatible with Windows 2000 and Windows Me. For details, see the
IX2-BSW's help file.
When your GX Series motorized system uses the IX2-UCB (Type 2) control box and U-HSTR2 hand switch,
read this “Important" section and “GX Series Motorized System" section on pages 11 to 16.
Please do not use this control unit with BX2 series components.
SAFETY PRECAUTIONS
1. Before connecting cables, be sure to set the main switch of the IX2-UCB control box to “ ” (OFF)”.
2. Make sure to ground the equipment for safety and for maintaining the electrical safety performance.
3. When installing the control box, leave spaces of more than 10 cm around it. (Note that the control box also has a
ventilation air inlet on the front panel).
4. Never insert a metallic object, etc. into the air vent of the control box. Otherwise, electric shock or malfunction may result.
Also be careful not to allow the provided small articles, including the push ring driver and Allen wrench, enter the air vents
of the associated module used together with the control box.
5. Distribute the power cord and other cables away from the lamp housing and its surroundings. Otherwise, the cord or
cable coating may melt by heat and cause an electric shock hazard.
The following symbols are found on the unit. Study the meaning of the symbols and always use the equipment in the
safest possible manner.
Safety Symbols
Symbol Explanation
Before use, carefully read the instruction manual. Improper use could result in personal injury
to the user and/or damage to the equipment.
Indicates that the main switch is ON.
Indicates that the main switch is OFF.
l
Indicates the illumination, which is limited only to a 12 V, 100 W halogen bulb with this system.
Bottom surface is hot, and should not be touched with bare hands.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General