Olympus OM-1 - Excessive or Insufficient Film Advancement

E-5
(2) If insufficient engagement is found in the vertical direction,
o Bend 8592 and adjust
o Adjust tolerance on 8592
o Replace 8592
o Replace the Gear A (the whole assembly of 8543)
4. Excessive or insufficient film advancement for Shutter-Charging
1) Improper adjustment of Eccentric Screw (8809)
In case of insufficient film advancement, loosen two HK1.4-102BO
to widen the distance at A by adjusting (8809).
In case of excessive film advancement, narrow the distance at A
by adjustment of (8809).
Care must be taken not to make an over adjustment casuing the
mechanism unchargeable.
Prior to film advancement, when the Gear A is pressed in the
arrowed direction, the distance between 8840 and the Gear A
should be -0.10 ''-'+0.3. (-0.10 means the state where
the Gear A comes in contact with 8840 and further moves by
0.1.)
http://oIympus. dementia •g/Hardware