Olympus OM-1 - Shutter Timing

E-24-
When Claw A is shaken if its lower edge hits the Gear B, an adjustment
may be made by bending the Plate (B).
Checkup
Vertically, Claw A and the Gear B should be engaged with each other
for more than 2/3 of their thickness.
3 ) Shifts in releasing force of Claw A.
Where there is an extreme shifting in the releasing force the portion
of 8567 (Shaft), 8501 (Plate) and the Plate B where they fit with each
other, should be cleaned. Then rub Claw A several times.
Checkup
While the release button remains depressed at the shutter speed "B“,
Xse iL shutter with 8595. Releasing Claw A with a tension gauge,
measure it. It should show the valve of 5 - 15g.
4. Shutter Timing
1) Positions
cf CAS575 (Cam) and CA8576 (Cam) at each speed:
CA8576
CA8575