Olympus OM-1 - Page 115

E— 19
Make fine adjustment on the alignment of the Patch of 8600 and
the Scratched-Line on the die-cast by adjusting the 5 holes'
positions.
Tolerance: 0 - 0.3mm
(From the point of perfect coincidence with the Scratched-
Line up to 0.3mm passing it.)
(5) Return 8521 to the original position and tighten 8857 (Shaft).
(6) Loosen PUK1.4 x 1.8SO of 8522 (Stopper), slide aside the 8522,.
and raise 8519 (Shaft) to release its engagement with the Gear A.
(7) While keeping the proper relationship between the Gears A and B
(items (1) through (3) above), rotate (8519) until 8538 (Curtain)
reaches closest to the Scratched-Line on the Die-Cast (see®in the
illustration in page l8 ), and lower (8519) until it gets engaged
with the Gear A.
Make fine adjustment on the alignment of the Patch of 8538 and
Scratched-Line on the die-cast by adjusting the 5 holes'
positions.
, +0.15
Tolerance: 0. mm
(8) Return 8522 (Stopper) to the original position and tighten PUK1.4 x
1.8SO.
a.o re/Hardware
http://olvmpus.dementi