Olympus OM-1 - Page 73

D-7
Engage CA8611 (Spring) as shown in the illustration below.
10) R emove XCA8404 (Screw)
Then will come off in a unit.
CA8606 (Cam)
CA8605 (Cam)
CA8575 (Cam)
CA8576 (Cam)
CA8577 (Gear)
3PUK1.4 x 5.5SO
PUK1.4 x 2SO
11) Take off PSK1.4 x 2SO which fastens CA8543 (Shaft) and loosen
XCA8545 (Screw) to remove the following parts.
XCA8567 S.M.L. (Shaft)
XCA8556 (Lever)
Caution: Simply loosen XCA8545 (Screw) alone, because
if it is completely removed, CA8543 (Shaft) is
separated.
After removing XCA8567 (Shaft), and XCA8556,
XCA8545 should be always fastened again.
12) Remove XCA8843 (Shaft) using the tool KC-CA8843G.
Then comes off CA85 43.
http://olympus.dementia.org/Hardwarc