EasyManua.ls Logo

Olympus U-LGPS - Maintenance and Storage; Cleaning Procedures; Post-Use Cautions and Storage; Product Lifetime

Olympus U-LGPS
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
U-LGPS
Maintenance and Storage
Cleaning of each portion
Cautions after use
· Remove dust around the ventilation openings of the product with a vacuum-cleaner, etc.
Using the dusty product continuously may result in a fire or failure of the product.
· Do not spray the product with flammable gas. Do not use the product near the spray containing
flammable gas.
Fire may be caused.
Do not use organic solvents because they may deteriorate the coated surface or plastic parts.
· Clean the product periodically (every 100 hours as a guide).
· Wipe the product with a dry soft cloth. If the dirt cannot be removed by dry-wiping, moisten a soft cloth with
diluted neutral detergent and wipe the dirty surface with it.
· Blow off the dust attached to the edge surface of the liquid light guide with clean air.
WARNING
NOTE
TIP
· After using this product, set the main switch of U-LGPS to (OFF), wait until U-LGPS is cooled down
sufficiently, and keep it covered with a dust cover during storage.
· Do not store the product in the environment where the condensation is caused by moisture or humidity.
TIP
Lifetime
The lifetime of this product is approximately 8 years after purchase if the product is used properly according
to this instruction manual.
(except consumables)
TIP

Related product manuals