Olympus U-LGPS - Operating Procedures; Turning ON the Lamp; Turning OFF the Lamp

11
U-LGPS
2
2 Operating Procedures
This section describes the basic operating procedures of each portion.
Set the main switch
A
on the back of U-LGPS to
(ON).
· The pilot lamp
B
on the front of U-LGPS turns ON (green).
· The numeral characters or texts are displayed on the counter
D
on the front of U-LGPS.
When using U-LGPS control software:
Turn ON the power of the PC (control PC) where software is installed,
and start the U-LGPS control software.
1
TIP
Press the lamp switch
C
on the front of U-LGPS.
· The color of the pilot lamp
B
on the front of U-LGPS turns to
blue.
· Pressing the lamp switch
C
allows you to select ON or OFF
of the lamp.
· You can check the status of the lamp by the color of the pilot
lamp. For details, see page 12.
2
TIPTIP
1
Turning ON the lamp
2
Turning OFF the lamp
A
A
C
D
Set the power switch
A
to
(OFF).
· The pilot lamp
B
on the front of U-LGPS turns OFF.
· The numeral characters or texts on the counter
D
on the
front of U-LGPS disappear.
When using U-LGPS control software:
Turn OFF the power of the control PC.
2
TIP
D
B
C
DB
Press the lamp switch
C
of U-LGPS.
· The color of the pilot lamp
B
turns to green.
· The cooling fan may keep working for cooling purpose.
When the cooling is finished, the cooling fan stops
automatically.
When using U-LGPS control software:
Turn OFF the power of the control PC.
1
TIP