Preparation for Use
MOBILE WORKSTATION WM-DP1
12
4.2 Shelf positions
NOTE
The WM-DP1 mobile workstation is supplied with the shelves fitted as
shown in Figure 4.1. It is recommended that shelves are repositioned, if
required, before commencing equipment installation as described
below.
1. Position the mobile workstation on a flat surface and apply both castor brakes (diagonally
opposed).
2. Referring to Figure 4.2, use the 6mm A/F L-wrench to remove the four M8 screws with
crinkle and plain washers from the underside of the shelf.
3. Locate the shelf at the new position and fit the four side fixing screws with crinkle and plain
washers. Tighten all screws using a 6mm A/F L-wrench. It is recommended that after fitting,
the screws are tightened to a torque of 10.5Nm (tool not provided).
Figure 4.2
To Next Page
Loading...
