Preparation for Use
MOBILE WORKSTATION WM-DP1
14
4.4 Equipment installation
refer to section 4.1for additional information regarding system installations.
CAUTION
• To minimise risk of injury, it is recommended that two people, working
together, place heavy items of equipment on the mobile workstation.
• High intensity light sources may need to be connected to a properly
grounded AC power outlet and not one of the IEC power sockets on the
mobile workstation, depending on the total system power rating.
• Ensure the fully installed system meets the requirements of
EN IEC 60601-1-1:2001, Medical Electrical Equipment, Collateral
Standard: Safety Requirements for Medical Electrical Systems. For
advice, contact your Olympus representative or qualified service
personnel.
NOTE
Releasable cable straps are provided on the rear of each shelf and
cable ties are provided to secure equipment power cables to the case of
the transformer. Cable access holes are provided in the base of the
mobile workstation. Excess lengths of cables should be coiled neatly
and secured to the rear of a shelf using the cable straps provided.
1. Place items of equipment centrally on the shelving and connect according to individual
instructions. The WM-DP1 mobile workstation is supplied with a universal IEC lead set to
connect equipment on the mobile workstation to the transformer. Potential equalisation
terminals are fitted to both sides of the transformer enclosure for connection to equipment
potential equalisation terminals where fitted. Route all cabling neatly in the side column cable
ducts on the extrusion and along the rear of the shelves, secure using the releasable cable
ties (see Figure 4.4).
Centre column cable ducts are used for interconnection of equipment located on the base,
intermediate and upper shelves.
To Next Page
Loading...
