Olympus WS 700M - Changing Time and Date

18
1
EN
Setting time and date
Setting time and date [Time & Date]
+− button
9 0 button
OK `/ MENU
button
STOP (4) button
Changing the time and date
5 Press the OK `/ MENU or 9
button.
• [Time & Date] will appear on the
display.
• The “Hour” will flash on the display,
indicating the start of the Time and
Date setup process.
3 Press the OK `/ MENU or 9
button to move the cursor to the
item to set.
• [Device Menu] will appear on the
display.
4 Press the + or − button to select
[
Time & Date ].
1 While the recorder is during
stop mode, press and hold the
OK `/ MENU button.
• The menu will appear on the display
(☞ P.47 ).
2 Press the + or − button to select
[ Device Menu ] tab.
• You can change the menu display by
moving the settings tab cursor.
While the recorder is during stop
mode, press and hold the STOP (4)
button to display the [Time & Date]
and [Remain]. If the current time and
date is not correct, set it using the
procedure below.
The following steps are the same as
Step 1 through Step 3 of “Setting time
and date [Time & Date]” (☞ P.17 ).
6 Press the STOP (4) button to close
the menu screen.