Omega Engineering i Series User Manual

3.2.12 Display Color Selection Menu
The menu below allows the user to select the color of the display.
Figure 3.10 Flow Chart for Display Color Selection Menu
ENTER DISPLAY COLOR SELECTION MENU:
Press
a
1) Press
a
, if necessary, until
CNFG
prompt appears.
Press
d
2) Display advances to
INPT
Input Menu.
Press
a
3) Press
a
, if necessary, until Display advances to
COLR
Display
Color Selection Menu.
Press
d
4) Display advances to
N.CLR
Normal Color Submenu.
NORMAL COLOR DISPLAY SUBMENU:
Press
d
5) Display flashes the previous selection for “Normal Color”.
Press
b
6) Scroll through the available selections:
GRN
,
RED
or
AMBR
.
Press
d
7) Display shows
STRD
stored message momentarily and then
advances to
1.CLR
only, if it was changed, otherwise press
a
to advance to
1.CLR
Alarm 1 Display Color Submenu.
The menu below allows the user to change the color of display when alarm is
triggered.
ALARM 1 DISPLAY COLOR SUBMENU:
Press
d
8) Display flashes previous selection for “Alarm 1 Color Display”.
Press
b
9) Scroll through the available selections:
GRN
,
RED
or
AMBR
.
Press
d
10) Display shows
STRD
stored message momentarily and then
advances to
2.CLR
only, if it was changed, otherwise press
a
to advance to
2.CLR
Alarm 2 Display Color Submenu.
40

Omega Engineering i Series Specifications

General

Brand	Omega Engineering
Model	i Series
Category	Measuring Instruments
Language	English