Section 1 - Introduction
Your CSi32 series benchtop controller is ideal for laboratory use and
applications requiring portable temperature or process control. Pre-wired
input and output receptacles on the rear panel enable quick and easy
connections to main ac power, signal input, control output and two way digital
communications. These controllers are factory configured and calibrated for
a dedicated input type by model number. It is important that you read this
manual and controller manual number M3355 completely and follow all safety
precautions in both manuals before operating this unit.
1.1 Precautions
• FOLLOW ALL SAFETY PRECAUTIONS AND OPERATING
INSTRUCTIONS OUTLINED IN THIS MANUAL.
• KEEP OUT OF REACH OF ALL CHILDREN.
• DO NOT OPERATE IN FLAMMABLE OR EXPLOSIVE ENVIRONMENTS.
• NEVER OPERATE WITH A POWER CORD OTHER THAN THE ONE
PROVIDED WITH YOUR UNIT.
• REMOVE AND OR DISCONNECT MAIN POWER CORD BEFORE
ATTEMPTING ANY MAINTENANCE OR FUSE REPLACEMENT
• DO NOT CONNECT AND OR OPERATE THIS UNIT TO AN NON-
GROUNDED, NON-POLARIZED OUTLET OR POWER SOURCE.
• DO NOT RECONFIGURE THE INPUT TYPE FACTORY SET IN THE
CONTROLLERS PROGRAM. INCORRECT READINGS AND/OR
CONTROL MAY RESULT.
NOTE:
There are no user serviceable parts inside your unit.
Attempting to repair or service your unit may void your
warranty.
1.2 Safety Warnings and IEC Symbols
This device is marked with international safety and hazard symbols in
accordance with IEC 1010. It is important to read and follow all precautions
and instructions in this manual before operating or commissioning this device
as it contains important information relating to safety and EMC. Failure
to follow all safety precautions may result in injury and or damage to your
calibrator. Use of this device in a manor not specified by the manufacturer
may impair protection provided within the unit.
IEC symbols Description
Figure 1. IEC Symbols
1
Introduction
1
Caution, refer to accompanying
Caution, risk of electric shock
To Next Page
Loading...
