Section 2 - Installation
2.1 Unpacking
Remove the packing list and verify that you have received all your equipment.
If you have any questions about the shipment, please call our Customer
Service Department at 1-800-622-2378 or 203-359-1660. We can also be reached
on the Internet at omega.com, e-mail: info@omega.com
When you receive the shipment, inspect the container and equipment for any
signs of damage. Note any evidence of rough handling in transit. Immediately
report any damage to the shipping agent.
NOTE:
The carrier will not honor any damage claims unless all shipping
material is saved for inspection. After examining and removing
contents, save packing material and carton in the event
reshipment is necessary.
The following items are supplied in the box:
• CSi32 Series benchtop Controller (1 each)
• This Users Guide and Controller Manual #M3355, iSeries Temperature &
Process Controllers (1 each)
• Power Cord (1 each)
• Mating Input Connector(s), Thermocouple Model (1 each) standard OST
Series male and (1 each) miniature SMP Series male.
• DB9-R12 Cable/Adaptor (1 each) Communication models only.
• Communications Manual #M3397 (1 each) Communications models only.
2.2 Power Connection
2.2.1 108 to 125 Vac, 50/60 Hz Model
Your Benchtop Controller comes with a standard North American 3-prong AC
power cord. Do not use any other power cord other than the one provided.
This cord provides the proper grounding and has been safety tested by the
proper safety agencies.
CAUTION:
Electrical connections and wiring should be performed only by
suitably trained personnel.
3
Installation
2
To Next Page
Loading...
