23
Installation (continued) Step Four
3. Flange: If installing on a flange, select a flange with a minimum thread of 2” thread that is above
the plane of the flange, such as the LVU800-2F.
a. Use a flange with a 3” thread and add a 3” to 2” reducer bushing to complete the installation.
2” Flange w/
thread out of plane
(LVU800-2F)
3” Flange (LVU800-3F)
w/ Reducer Bushing
(LVU800-3N80)
4. Side Mount Bracket: For installations in open tanks and sumps, use the LVM-30 series side
mount bracket.
LVM-30 Shown
Note: The Side Mount Bracket (LVM-30 series) is not designed for use with stand pipes or as a
method to secure stand pipes. There are too few threads to properly hold the sensor and the
stand pipe.
To Next Page
Loading...
Need help?
General
