Using the Infrared Thermometer/Transmitter
3
3-24
3.5.11 Erasing the Temperature Data from Memory
The user can erase all 800 temperature data points in
memory at any time by using the following procedure:
1. Turn on the transmitter.
2. Press the
key until reaching the MEM or LOG
display mode.
3. Press the then keys in rapid sequence. The
display shows ERASE on the top and it will beep to
indicate that the stored data is erased.
Erasing the temperature data does not erase or
reset Emissivity, High and Low Alarm setpoints,
printing interval and Ambient Target Temperature
compensation
NOTE
To Next Page
Loading...
