Omron BP791IT - Selecting the User ID; Using the User ID


Select.your.USER.ID.Always.use.the.same.USER.ID.when.taking.
a.measurement.The.monitor.stores.the.measurement.values.in.the.
memory.by.the.USER.ID.selected.These.measurement.values.are.used.
to.calculate.the.Morning.Averages.and.Evening.Averages
Slide.the.USER.ID.Selection.Switch.right.or.left.to.select.USER.A.or.B

After.you.select.a.USER.ID,.the.monitor.can.be.set.to.take.one.
measurement.using.the.Single.Mode.or.three.consecutive.measurements.
using.the.TruRead
TM
.Mode
NOTE:..The.default.value.is.set.to.the.Single.Mode.to.take.one.
measurement.Refer.to.“Setting.TruRead
TM
”
TAKING A MEASUREMENT
32