30
flashes
There are more than
24 readings in memory to
be transferred.
Pair or transfer your
readings to the receiver
so you can keep them in
memory in the receiver,
and this error symbol
disappears.
Your monitor is not paired or
not connected with the
receiver.
appears
There are 30 readings in
memory to be transferred.
flashes
Batteries are low.
Replacing all 4 batteries
with new ones is
recommended. Refer to
sub-section 2.1.
and
appears or the monitor
is turned off
unexpectedly during a
measurement.
Batteries are depleted.
Immediately replace all
4 batteries with new ones.
Refer to sub-section 2.1.
Nothing appears on the
display of the monitor.
Batteries are depleted.
Battery polarities are not
properly aligned.
Check the battery
installation for proper
placement. Refer to sub-
section 2.1.
Display/Problem Possible Cause Solution
To Next Page
Loading...
Need help?
General
